Westec Apollo Basics
Do not power down this system. Use the sleep switch in the panel |
| Downloadable | No | ||||||
| Panics |
|
||||||
| Arm | Arm Code (must have ready light) | ||||||
| Arm Interior | press DOOR CHIME/INTERIOR before arming | ||||||
| Disarm | Disarm Code (entry/exit time will beep when entering a door) | ||||||
| Cancel Alarm | Disarm Code | ||||||
|
Silence Trouble Beep |
press SHUNT + 0 + ZERO CODE | ||||||
| Instant | Press to enable Entry/Exit time, press again to disable | ||||||
| Bypass(Shunt) | SHUNT + Zone # (Repeat to bypass more zones, Zones will flash until bypass removed) | ||||||
|
Remove Bypass |
Press Shunt key or Arm and Disarm system | ||||||
| Alarm Memory | Zone will flash, to remove flashing zone press SHUNT + TEST or Arm System | ||||||
|
Enable/Disable Chimes |
Press INTERIOR CHIMES to enable, press again to disable | ||||||
| Test | Press TEST + Zero Code | ||||||
| Reset Smoke |
Open door on control panel push DC POWER SWITCH to OFF, then puch the DC POWER SWITCH to ON and immediately press TEST four times. |
||||||
| User Codes | |||||||
| Secondary |
Enter Programming by pressing SHUNT + TEST + Zero Code Enter additional code and then press TEST (repeat for more codes) (no two code can begin with the same digit) |
||||||
| Delete |
Enter Programming by pressing SHUNT + TEST + Zero Code Enter the first digit of the code you wish to delete then press TEST (no two code can begin with the same digit) |
||||||
| Zero Code | Slide DC POWER SWITCH to OFF, then to ON now press zero code (up to 5 digits) the press test four times | ||||||
| Test Code |
Turn system on/off go to the keypad and push 0 button then enter the code you want. Then hit the test button 4 times and then press 0 button. |