1. Home
  2. Westec
  3. Westec 6000
  4. Westec 6000
 

Westec 6000 Basics


This panel CAN lose power without losing programming

Batteries
System 12 volt rechargeable Gel-Cell inside main panel
Door/Windows 3 to 4 AAA Alkaline
Motion Sensor 4 AAA Alkaline
Smoke Detector 6 AA Alkaline
4-button Keyfob Button type batteries #LR44
Pendant Panic Non-Replaceable
Downloadable No
Panic Buttons Police, Fire and Medical
Arm Away 4-digit Code or press AWAY 3 seconds (ARM light will turn ON)
Arm Stay 4-digit Code or press STAY 3 seconds (ARM and BYPASS turs ON)
Quick-Arm * 0 to Arm system (If Enabled)
Instant Arm * 9 before arming in STAY or AWAY (Arm light will flash)
Disarm 4-digit Code (Press # if any mistake is made)
Silence Alarm 4-digit Code (Press # to stop keypad flashing)
Bypass 1. Press * 1 (BYPASS or SYSTEM will flash)
2. Press Zone to bypass (01 to 32) (Zone light should turn ON)
3. Press # to exit
(If this does not work try * 1 + Master Code + (01 to 32) + # )
Reset Smoke Enter code twice
Door Chime Hold CHIME key for 3 seconds or * 4 to enable/disable
RESET Key Resets Smoke Detectors
EXIT Key Press to leave house without disarming, doors will arm again after 2 minutes
Alarm Memory * 3 to view last alarm or for Alpha keypads see below
Event Buffer 1. Press * 6 + Master Code
2. Press < or > keys to scroll to “Event Buffer” then press *
3. Use < key to move forward in time, use > key to move backward in time
4. Press * to toggle between Time/Date of Event and what the Event was

Examples: Closing by User 40 = Master Code Armed System
Opening by User 01 = User 01 Disarmed system
Zone Fault Zone 24 = Zone 24 is in trouble

Sensor Test None, Arm system then trip sensors
(Wireless motions require no movement for 4 minutes prior to testing)
Siren Test * 6 + Master Code + 4
Change Time/Date 1. Access code + 9
2. Scroll to “Set System Time” with the (< >) Arrow keys and press *
3. Enter Current time in 24 hour format (HH:MM)
4. Use Arrow keys to scroll to “Set System Date” and press *
5. Enter Current Date (MMDDYY)
6. Press # #
Keypad Tone Hold * until desired volume is found
Access Partition (If keypad is set for Global)
1. Press # for 2 seconds
2. Press 1 for 2 seconds for Partition 1, 2 for Partition 2
Auto Arm * + 6 + Master Code + 2 (3 beeps=Enable, 1 long beep=Disable)
Auto Arm Time * + 6 + Master Code + 3 + HHMM (Military Time)