Westec 4000 Basics
Panel does not lose memory when power is lost
Panic Buttons |
|
||||||
Downloadable | No | ||||||
Check Status |
press ENTR and hold for 2 beeps On – System is armed A – Interior A is enabled b – Interior B is enabled In – Instant is enabled bP – Bypass is enabled ch – Chime is enabled cod – Temporary user code is enabled |
||||||
Power Down | Easiest way is to use ON/OFF switch on board (See Wiring) | ||||||
Disarm | USER CODE + ENTR + OFF + ENTR (ON, INT A, INT B will turn off) | ||||||
Arm Perimeter | USER CODE + ENTR + HOME + ENTR (ON light will turn on) | ||||||
Quick-Arm Perimeter |
Press HOME and hold for 2 beeps | ||||||
Arm Per & Int |
USER CODE + ENTR + ALL + ENTR (ON, INT A, INT B lights will turn on) | ||||||
Quick-Arm Perimeter |
Press ALL and hold for 2 beeps & Interior | ||||||
Arm Interior | A USER CODE + ENTR + INT A + ENTR (INT A light will turn on) | ||||||
Quick-Arm Interior |
A Press HOME and hold for 2 beeps | ||||||
Arm Interior | B USER CODE + ENTR + INT B + ENTR (INT B light will turn on) | ||||||
Quick-Arm Interior |
B Press INT B and hold for 2 beeps | ||||||
Instant Enable/Disable |
USER CODE + ENTR + INST + ENTR now arm system (INST light will turn on) turning system off disable feature | ||||||
Quick Instant | Press INST B and hold for 2 beeps | ||||||
Bypass & Arm Interior |
USER CODE + ENTR + HOME + BYPS + ENTR (led light bYP will turn on) | ||||||
Bypass & Arm Perimeter |
USER CODE + ENTR + ALL + BYPS + ENTER (led light bYP will turn on) | ||||||
Chimes | USER CODE + ENTR + CHIME + ENTR (CHIME light will turn arm) | ||||||
Quick Chimes | Press CHIME and hold for 2 beeps | ||||||
Clear Incorrectly Pressed Button |
CLR | ||||||
Exit Command Mode |
CLR press and hold for 2 beeps | ||||||
Silence Enable |
USER CODE + ENTR + OFF (hold for 2 beeps) + ENTR ( small decimal point will appear on the LED and will continue to (quiets keypad beeps) flash showing it is quiet mode) (must be done at each keypad) |
||||||
Silence Disable | USER CODE + ENTR + OFF (hold for 2 seconds) + ENTR (small decimal point will disappear) | ||||||
Reset Smoke Silence Trouble |
CLR | ||||||
Test |
USER CODE + ENTR + TEST + ENTR This will take approximately 10 minutes. The green PWR light will flash, then the siren will sound for 60 seconds and then the 888 and rdY lights will altrnately flash (if there are open zones they will also flash). Can test individual zones and hear a “beep, beep” to let you know that the zone is working properly. |
||||||
User Codes | |||||||
Duress Code | 1 digit above Code (if code is 1234 Duress is 1235) | ||||||
Add Temp Code | USER CODE + ENTR + CODE + Temp User Code (2 to 10 digits long) + ENTR | ||||||
Enable/Disable Temp Code |
USER CODE + ENTR + CODE + ENTR (when enabled OPT A or OPT B light will turn on) |