Videofied XT-IP610 Program

For the XL Series Panels: Open the control panel, press the INIT (programming) button for 8 seconds using your finger (The LED button will flash twice to confirm the system reset).

For XL/XT Series Panels: Using the right arrow key, scroll to ACCESS LEVEL , select [Yes/Ok] , scroll to ACCESS LEVEL: 4 with the directional arrows, press [Yes/Ok] to save the new access level, enter your installer access code, press [Yes/Ok] . When working with some models of the XL/XT series panel, you may be prompted to enter in a level 3 user code. In this case, you will need to enter in a level 3 code, which will be different than the installer code. Following the entering of a level 3 code, you will be granted access to level 4, the installer level.

Scroll to CONFIGURATION (level 4), confirm using the [Yes/Ok] key, scroll to AREAS AND DEVICES , confirm using the [Yes/Ok] key, scroll to DEVICES, confirm using the [Yes/Ok] key, scroll to ADD A NEW DEVICE , confirm using the [Yes/Ok] key, press the program button on the device, the keypad will confirm the adding of the device with [DEVICE] # RECORDED , complete optional device configuration (if any). Double check the RF signal using DEVICE LOCATING under the MAINTENANCE menu. A consistent 9/9 signal is REQUIRED for proper system function. A range test should be done after device addition and after device installation in it’s permanent location.

When you delete a device and add it back into the control panel it will take the lowest available slot/number.

EXAMPLE:

Keypad = Slot 1
Camera1 = Slot 2
Camera2 = Slot 3
Camera3 = Slot 4
Camera4 = Slot 5

If you delete the camera out of slot 2 and add it back in it will go to slot 2.