| Installation – Auto-Recognition (supported systems) |
| 1. Unplug receiver from the wire harness |
2. Wire the Red, Black, Yellow and Green to the keypad terminals of panel
| RED |
Connect to Keypad Red or Aux (+) |
| BLACK |
Connect to Keypad Black or Aux (-) |
| GREEN |
Connect to Keypad Green |
| YELLOW |
Connect to Keypad Yellow (Moose ZX panels connect to Keypad White) |
| BROWN |
Connect to Zone Common (Optional) |
| BLUE/GREEN |
Connect to Zone (Optional) |
| BROWN/WHITE |
Connect to Zone if N/O required instead of BLUE/GREEN (Optional) |
|
3. Plug harness into receiver, LED blinks 1 time on power up, after 2 seconds count flashes
| Flashes |
Alarm Panel detected |
| 1 |
No Alarm Detected (Relay Mode) |
| 2 |
Napco 1008LKDL/1000E/1008E/1016E |
| 3 |
Moose Z700/880/900/950 |
| 4 |
Caddx 8600E/8980E |
| 5* |
Ademco Non-Addressable (4110/4120/Vista-10/Vista-20 etc)*/First Alert |
| 6* |
Ademco Addressable Address 3 (Vista-40/50/100)*/First Alert |
| 7 |
DSC PC580/1555/5010 (PC1575 works only in Relay mode) |
| 8 |
DSC 1550/2525/2550/3000 |
| 9 |
Moose ZX200-210/ZX300-310/ZX400-410 |
| 10 |
Moose Z1100E, Z900/Z950 |
| 11 |
Nothing listed |
| 12 |
Moose Z1100 |
*Ademco panels must use have 6128 keypads or higher or Panic Button will not work
(however you can use Relay 3 to activate zone programmed as 24 Hour Police Panic)
|
|
Press and Release Button to Arm/Disarm
Press and HOLD for 3 seconds to activate Panic
|
Jumpers
| Panic |
Jumper closest to harness ON (Default) |
| Medical |
Jumper closest to harness OFF |
| Delay Activation |
Jumper farthest from harness ON (Default) |
| Instant Activation |
Jumper farthest from harness OFF |
|
| Installation – Relay Mode (non-supported systems |
| 1. Unplug receiver from the wire harness |
2. Wire the Red, Black, Yellow and Green to the keypad terminals of panel
| RED |
Connect to Keypad Red or Aux (+) |
| BLACK |
Connect to Keypad Black or Aux (-) |
| BROWN |
Zone Common |
| BROWN/WHITE |
Zone programmed as Panic |
|
3. Add Remote by pressing then releasing the program button on receiver
Receiver light will turn ON, press button on remote 3 times, light should turn OFF
|
| Add Remotes |
1. Press then releasing the program button on receiver
2. Receiver light will turn ON, press button on remote 3 times, light should turn OFF
|
| Delete Remotes |
| 1. Press and Hold program button, light will turn ON for 4 seconds then OFF then ON again |
