Street Smart VSMR Program
Installation Instructions | |||||||||||||||||||||||||||||||||||||||||||||||
1. Unplug Harness from Voice Module, wire Red, Black, Yellow and Green to keypad terminals 2. Power up system, LED on Voice Module should flash indicating panel detected
Voice Module learns as Address #3 on Ademco Addressable and #4 on Moose ZX systems Green Wire is not used on Caddx or Napco GEM P400/P800/XP400/XP-600 |
|||||||||||||||||||||||||||||||||||||||||||||||
Change Address | |||||||||||||||||||||||||||||||||||||||||||||||
1. Unplug Harness from Voice Module 2. Press and Hold STATUS, while holding STATUS plug Harness in 3. Release STATUS and press number of times for address desired, LED will flash new address |
|||||||||||||||||||||||||||||||||||||||||||||||
Learning User Code (Do not use Master Code) | |||||||||||||||||||||||||||||||||||||||||||||||
1. Press and Hold RECORD, PLAY, AWAY, STAY at same time 2. Voice module will say “Enter User Code” 3. Release button and LED will flash, slowly enter User Code, LED will stop flashing |
|||||||||||||||||||||||||||||||||||||||||||||||
Select Voice Chime Zones | |||||||||||||||||||||||||||||||||||||||||||||||
1. Press and Hold RECORD and AWAY buttons until voice module says “Chime” 2. Release buttons, press RECORD or PLAY to scroll through zones 3. Press AWAY to turn Chime ON for that zone, press STAY to turn Chime OFF 4. Press STATUS twice to exit |
|||||||||||||||||||||||||||||||||||||||||||||||
Enable Voice Chime Mode | |||||||||||||||||||||||||||||||||||||||||||||||
Press and Hold STATUS button for 3 seconds (Voice module should say “CHIME ON” or “CHIME OFF”) Note: Voice update is slow on Ademco panels due to keypad’s normally slow display |
|||||||||||||||||||||||||||||||||||||||||||||||
Change Volume | |||||||||||||||||||||||||||||||||||||||||||||||
Press and Hold PLAY button for 3 seconds, Voice module should say “Volume” Keep pressing through 4 possible volume levels |
|||||||||||||||||||||||||||||||||||||||||||||||
Disable Voice | |||||||||||||||||||||||||||||||||||||||||||||||
Press and Hold AWAY & STAY buttons, Voice Module will say “Voice OFF”, repeat to re-activate | |||||||||||||||||||||||||||||||||||||||||||||||
Reset to Default | |||||||||||||||||||||||||||||||||||||||||||||||
1. Unplug Harness from Voice Module 2. Press and Hold PLAY button while plugging Harness back in for 5 seconds |
|||||||||||||||||||||||||||||||||||||||||||||||
Programming Voice Descriptions (each zone can have 3 zone descriptions) | |||||||||||||||||||||||||||||||||||||||||||||||
1. Press and Hold RECORD and PLAY until Voice Module says “Zones” 2. Use RECORD and PLAY buttons to scroll Up and Down to select Zones 3. Use AWAY and STAY to scroll through Vocabulary from A to Z words 4. Press STATUS to save word and move to next word or RECORD and PLAY for next Zone 5. After 3rd word within Zone is programmed Voice Module will say “Zones”, move to next Zone 5. To exit press STATUS twice, Voice Module will say “Exit Now” Note: Voice Module can handle maximum of 16, any zones above may not sound
|