Installer’s Code (Code 0)

    Your installation company uses this special code to install and initially
    program your system. It can also be used to arm and disarm your system,
    both from the touchpads and from the central station (by telephone lines). If you do not want the installation company to have access to your system
    once it has been installed, ask the installer for the installation code and
    instructions for changing it. Once you have changed the code, only you can
    arm and disarm the system.If it becomes necessary to change the
    programming of your system, you will have to give the installation company
    the new code. Talk to your installer about the installation code. There are
    many reasons why you might want your installation company to be able to
    access your system at any time.

    Main User’s Code (Code 1)

    (Warning: Without this number, it is virtually impossible for anyone to reprogram
    or reset your security system.)

    Code 1 (sometimes known as the master code) enables you to change other
    code numbers, and change the day and time shown on your touchpad liquid
    crystal display (LCD) and optional printer. This main user code number
    should be written down and stored for periodic use in a safe, secure place.
    Because code 1 can activate the Walk Test mode, during which the 4720 is
    temporarily prevented from responding to an actual fire alarm, code 1
    cannot be used by the end user in a UL commercial fire installation. Your
    installer must reprogram options and perform other tasks that require the use
    of code 1.

    Primary Access Codes (Codes 2-98)

    Up to 98 primary access codes can be provided by your security system.
    These primary codes are the basic keys to your security system. They can
    be programmed to allow the user to arm and disarm the system, operate all
    DOOR functions, and bypass system zones. Primary codes can be individually programmed with specific time windows
    appropriate for each employee or user. For example, night shift workers can
    be programmed for PM hours only, or part-time workers for their scheduled
    work hours only.

    Changing Your Access Code

    Access codes are 3 to 6 digits in length. You must be sure that codes do not
    conflict. For example, assigning a code as 543 would prevent another code
    previously assigned as 5432 from working.
    After entering a new access code, always remember to press the TEST
    button. You can record new access code numbers on page 29.
    Note: When changing codes, make sure that no code starts with the duress
    trigger digits (see page 12).

    1. Display the code you wish to change (Steps 1-6 in Displaying Codes).
    2. To change the access code displayed, press CLR.
    3. Enter the new access code you have assigned (3 to 6 digits).
    4. Store the new code in memory by pressing TEST.
    5. The display will then show the next access code in sequence. Repeat Steps
      1-3 for each additional code you wish to change.
      Deleting Codes

      Note: Do NOT delete your main access code.

    6. Display the code you wish to delete (Steps 1-6 in Displaying Codes).
    7. Press CLR to clear a code from memory without assigning a new code.
    8. Press TEST.