GE / ITI / UC Commander 2000 Trouble

POWER Light ON Normal
POWER OFF AC power is off and panel is running on Backup Battery
POWER FLASHING Backup Batteries Low (See Keypad Diagram
(Replace with same type, Lithium with Lithium, or it WILL be messy!)
TROUBLE ON (Press STATUS see list below for troubles)

“Zone xx Trouble” Zone battery dead, must be set for service
“Communication Failure” System can’t communicate, try sending signal
“Sensor 92 Trouble” Screws under keypad needs tightening
“Sensor 95 Trouble” AC Power came back on, everything is ok!
Reset Smoke 4-digit code + 1 (OFF)
Phone Test
1. Enter Master Code + 8 (Keypad says “Phone Test is ON”)
2. If Phone test fails (Keypad says “Phone Test Failure”)
3. If Phone test is good (Keypad says “Phone Test is OK”)
Sensor Test 1. Enter Master Code + 9 (Keypad says “Sensor Test is ON”)
2. Open Doors/Windows/walk past motion, press TEST on Smoke Det.
3. Keypad will beep and say “Sensor xx is OK”
(if zone has a problem or is open it will not beep)
4. Press Master Code + 1 (OFF) to end Sensor Test
Zone Trouble If zone is showing trouble customer can remove from system
1. Loosen 2 screws under keypad, lower bottom tray just a little bit
2. Press 4321
3. Press BYPASS + 2-digit zone number
4. Panel will say “Sensor xx Goodbye”
5. Raise bottom tray and tighten screws to exit
Sensor 97 Trouble Hardwire Siren sensor supervision trouble, 4.7K resistor must be across
siren terminals 13 & 14
Main Trouble and Event signals
01 to 18 Zone Alarms
80 Touchpad Fire Panic
81 Touchpad Police Panic
82 Touchpad Auxiliary Panic
83 Phone Test (Level 8)
84 Opening Report (Optional)
85 Closing Report (Optional)
86 Duress Alarm Report
87 Force Armed Auto
90 AC Failure
91 Low Battery
92 CPU Tamper
93 Auto Phone Test
94 Receiver Failure (Try changing batteries)
94 Invalid Sensor Number
95 CPU Back in Service
96 Fail To Communicate
97 Wiring problem with Exterior Siren (v5.3 only)
98 Auto Event Buffer