Optex Morse Genesys 824R Basics
| Zones | 8 zones, 16 more with 2 Zone expanders | ||||||
| Battery | 12 volt rechargeable Gel-Cell inside main panel | ||||||
| AC Transformer | 16.5 volts, screwed into outlet somewhere in house | ||||||
| Downloadable | Not at this time | ||||||
| Panic Buttons |
| ||||||
| Arm Away | User Code + AWAY (Ready Light must be on) | ||||||
| Arm Stay | User Code + STAY | ||||||
| Arm Instant | User Code + INSTANT (Interior Zones will be bypassed) | ||||||
| Quick Arm | ↑ + <Quick Arm Digit> + AWAY or STAY or INSTANT | ||||||
|
Enable Quick Arm |
1. User Code + ↑ + 8 + 8 2. Keypad will show “TO DISABLE <0>” and show current Quick Arm Digit 3. Enter any digit or 0 to disable + ↑ to save, # twice to exit |
||||||
| Disarm | User Code, if mistake is made press # | ||||||
| Scan Mode |
(Views open zones) 1. User Code + ↑ + 6 2. Scroll through Zones with 6 3. Exit with # (Standard Keypad shows “01:C” = Zone 1 Closed, “01:o” = Zone 1 Open) |
||||||
| Bypass 1 | User Code + BYPASS + Zone (01 to 24) (Keypad should beep twice) | ||||||
| Bypass 2 | Enter Scan Mode, scroll through zones, press BYPASS then # to exit | ||||||
| Alarm Memory | User Code + ↑ + 4 (4 cycles through last 16 alarms) | ||||||
| Exit | If Armed User Code + STAY (Exit delay will start again) | ||||||
| Door Chimes | User Code + ↑ + 1 (Enable/Disable) | ||||||
| Test Mode |
User Code + ↑ + 3 keypad displays all zones, opening will remove zone from list, if all zones tested [NO MORE FOUND] will show, enter code to exit |
||||||
| Reset Smoke | User Code + ↑ + 2 | ||||||
| Set Time |
1. User Code + ↑ + 8 + 3 2. Enter Military Time (1:30PM would be 13:30) then ↑ to save 3. Press # twice to exit |
||||||
| Quick Arm | ↑ + <Quick Arm Digit> + AWAY or STAY or INSTANT | ||||||
| Add Quick Arm |
1. User Code + ↑ + 8 + 8 2. Keypad will show “TO DISABLE <0>” and show current Quick Arm Digit 3. Enter any digit or 0 to disable + ↑ to save, # twice to exit |