2Gig Go! Control Keyfob

    Key Fob Programming

  1. Go to Q3: Select fob # (1 to 8).
  2. Fob used (0 to 1) or Fob enabled (0 to 1).

    • (0) unused or (0) disabled
    • (1) used or (1) enabled
  3. Select RF sensor equipment code. Enter 0866 for the 2GIG-KEY3-433 4‐button Key Ring Remote.
  4. Enter RF sensor serial number (7 digits).

    • Manual Entry: Type in the last 7 digits of the TX ID that is found outside of the box or on the back of the device.
    • Auto Entry: With the panel in Learn-in mode (press Shift then Learn). The correct TX ID should appear. Accept the correct TX ID by pressing OK.
  5. 5 Select RF sensor equipment age (0 to 1).

    • (0) new (product is new)
    • (1) existing (product already exists)
  6. Select fob emergency key (0 to 4).

    • (0) disabled
    • (1) auxiliary alarm
    • (2) audible alarm
    • (3) silent panic
    • (4) fire
  7. Select fob key 2 can disarm (0 to 1).

    • (0) disabled
    • (1) enabled
  8. Construct RF sensor voice descriptor. Press Insert then press any number between 002 and 255 to add a word.

    • Example: If you wanted to name this Key Ring Remote as “main key remote,” press Insert then press 138 for MAIN.
    • Press Insert then press 121 for KEY.
  9. 9 Select fob arm no delay (0 to 1).

    • (0) disabled
    • (1) enabled
  10. 10 Select fob key 4 output (0 to 2).

    • (0) disabled
    • (1) toggle output
    • (2) momentary output
  11. To program another sensor click next.
  12. To exit programming, click skip then end and exit. Upon exit, the panel takes a several seconds to reboot.

    • TIP: Each key fob that is learned in uses one of the available fob sensor numbers as programmed in step 1.