MA 2600 Codes

User Codes 16, must be changed with Master Program Code, (usually 123456)
if this is not known customer cannot change codes. User Codes can be 4 to 6 digits
Hostage/Duress 2 digits (usually 99) + User Code
Example: if Duress/Hostage Code is 99 and User Code is 4356 enter 994356 to activate

Adding Codes Older Keypads (6 panic buttons on bottom)
1. Raise keypad cover
2. Enter Master User Program Code (Default is 123456)
3. Press NEXT/NO DELAY to scroll to display “PROGRAM CODE”
4. Press NEXT/NO DELAY to scroll through user codes
5. Enter new 3 to 6 digit code then press SAVE
6. Close Cover to exit

Deleting Codes Older Keypads (6 panic buttons on bottom)
1. Raise keypad cover
2. Enter Master User Program Code (Default is 123456)
3. Press NEXT/NO DELAY to scroll to display “PROGRAM CODE”
4. Press NEXT/NO DELAY to scroll through user codes
5. Press 5 to blank out then press SAVE
6. Close Cover to exit

Adding Codes New Keypads (White with black stripe across top)
1. Press FUNCTION until display reads ACTIVATE PROGRAM, press ON/OFF
Note: Keypad may revert to normal display, go to step #2 anyway
2. Enter Master User Program Code, ARMED and STATUS lights should go out
3. Press INSTANT to move through User Codes
4. Use 1 & 2 to scroll left & right among digits, 4 & 7 scrolls Up & Down available digits
5. Save code by pressing ON/OFF
5. Press RESET to exit

Deleting Codes New Keypads (White with black stripe across top)
1. Press FUNCTION until display reads ACTIVATE PROGRAM, press ON/OFF
Note: Keypad may revert to normal display, go to step #2 anyway
2. Enter Master User Program Code, ARMED and STATUS lights should go out
3. Press INSTANT to move through User Codes
4. Use 1 & 2 to scroll left & right among digits and delete with 5 key
5. Save by pressing ON/OFF
5. Press RESET to exit