Napco 1008LKDL Keypad

Default Keypad Press 1 2 3 4 at same time, keypad will show **FORCED RESET**
Alpha Adjust Screw terminal back of keypad labeled Alpha ADJUST
Enter LCD Program (Enabling Panics)
1. Arm/Disarm, press # then 2
2. Press 4 until PANEL CONF is displayed
3. Display will show . . . .
4. Press 1, display will show . . . 1
5. Add 8 to the 1 for . . . 9
6. Press [B/A] to save then hold 8 for 3 seconds to exit
Exit LCD Program Press [B/A] then hold 8 key for 3 seconds
Zone Description 1. Arm/Disarm, press # then 3
2. Keypad will show ENGLISH MODE then 1-_ indicating zone 1
3. Press 1 (CURSOR LEFT) or 2 (CURSOR RIGHT) to move cursor under desired character
4. Press 5 (CHARACTER UP) or 9 (CHARACTER DOWN) to select desired letter or number
5. To change to to lower case hold down * key while scrolling with 5 or 9
6. Press 6 key to blank character, press * 6 to delete entire line
7. Press [B/A] to save this zone description
8. Press 4 (NEXT) to move to next zone or 8 (PRIOR) to previous
9. To exit hold 8 for 3 seconds
Transferring (from the already programmed keypad)
1. Hold 9 for 3 seconds until beep
2. Arm/Disarm, press # 1
Master keypad will show PLEASE WAIT SENDING ZONE ID