Napco MA1000E Keypad
![]() |
|
LCD Defaulting | Press 1 2 3 4 at same time, keypad will show **FORCED RESET** |
Display Adjust | Screw terminal back of keypad labeled Alpha ADJUST |
Enter LCD Program |
(Enabling Panics) 1. Arm/Disarm, press # then 2 2. Press 4 until PANEL CONF is displayed 3. Display will show . . . . 4. Press 1, display will show . . . 1 5. Add 8 to the 1 for . . . 9 6. Press [B/A] to save then hold 8 for 3 seconds to exit |
Exit LCD Program |
1000e or 1008e – Press [B/A] then hold 8 key for 3 seconds 1016 or 1016e – Press [B] then hold 8 key for 3 seconds |
Zone Description |
1. Arm/Disarm, press # then 3 2. Keypad will show ENGLISH MODE then 1-_ indicating zone 1 3. Press 1 (CURSOR LEFT) or 2 (CURSOR RIGHT) to move cursor under character 4. Press 5 (CHARACTER UP) or 9 (CHARACTER DOWN) to select desired letter 5. To change to to lower case hold down * key while scrolling with 5 or 9 6. Press 6 key to blank character, press * 6 to delete entire line 7. Press [B/A] to save this zone description 8. Press 4 (NEXT) to move to next zone or 8 (PRIOR) to previous 9. To exit hold 8 for 3 seconds |
Transferring |
(from the already programmed keypad) 1. Hold 9 for 3 seconds until beep 2. Arm/Disarm, press # 1 Master keypad will show PLEASE WAIT SENDING ZONE ID |