Moose Z2000 Wiring
| We cannot do downloads for any Moose panels! | |||||||
| Zones | 12 zones, expandable to 48 with Z2300 Zone Expander | ||||||
| Resistors | 2.2k | ||||||
| Fuses | 1 Amp for KP Power, 2.5 Amp for everything else | ||||||
| Battery | Standard 12 volt Gel-Cell inside main control panel | ||||||
| AC Transformer | 16.5 Volt 35 AH | ||||||
| Wireless | No | ||||||
| Downloadable | No | ||||||
| Partitions | Yes, up to 8 | ||||||
| Panic Buttons |
|
||||||
| Arming Modes |  |
||||||
| Check Status | Press MENU until ZONE STATUS displays, press key below to show open zones | ||||||
| Alarm Memory | Press MENU until ALARM HISTORY displays, press key below to display past alarms | ||||||
| Zone Bypass | Press MENU until BYPASS displays, press key below and enter zones to bypass | ||||||
| Not Ready | Press Function Key under DISPLAY to view it will also give option to BYPASS | ||||||
| Reset Alarms |
After alarm keypad will show violated alone and SILENCE DISPLAY Press function key under SILENCE and enter Pass code at prompt Display will show CLEAR and ENTER, select function under ENTER Display should show area silenced then zone that was in alarm press function key under QUIT or TIME to view when alarm occured Note: If you can’t get past ENTER PASSCODE may not have authority level |
||||||
| Reset Smoke |
1. Press function key below SILENCE and enter code 2. Press Menu (blue triangle) until display reads SMOKE RESET 3. Press key below SMOKE RESET If this does not work power down system, smoke detector is bad |
||||||
| Display Adjust |
Press MENU until display shows VIEWING ANGLE, ADJUST LAMP, ADJUST BEEPS Press key below for which function to program |
||||||
| Set Clock |
Press MENU until display shows SET CLOCK use keys below display to move left or right, press disired number to change AM to PM move cursor under and press any key |
||||||
| Force Arm | If display shows NOT READY press ARM key + User Code + AWAY + DISPLAY + BYPASS | ||||||
| Reset Alarm | Press MENU until display reads RESET ALARM, press key below RESET ALARM | ||||||
| Check Status | Press DISPLAY key, display will show open zones | ||||||
| Alarm Display | ARMED light is Flashing, keypad will show ALARM | ||||||
| Alarm Memory | Press MENU until display shows EVENT HISTORY, press key below to display alarms | ||||||
| Zone Bypass | If display shows NOT READY press ARM key + User Code + AWAY + DISPLAY + BYPASS | ||||||
| Door Chimes | Press MENU until display shows ENABLE CHIME, press key under ENABLE CHIME | ||||||
| Reset Smoke |
1. Press function key below SILENCE and enter code 2. Press Menu key (blue triangle) until display reads SMOKE RESET 3. Press function key below SMOKE RESET |
||||||
| Display Adjust |
Press MENU until display shows VIEWING ANGLE, ADJUST LAMP, ADJUST BEEPS Press key below for which function to program |
||||||
| Set Clock |
Press MENU until display shows SET CLOCK Use keys below display to move left and right within display Press disired number keys, to change AM to PM move cursor under, press any key |
||||||
| LED Keypad Commands (LED keypads are secondary to other LCD keypads) | |||||||
| Status Light | Must be ON to Arm | ||||||
| Arm | User Code + * | ||||||
| Disarm | User Code + * | ||||||
| ARMED Light | Indicates if Armed (ON) or Disarmed (OFF) | ||||||
| Alarm Light | If ON system has or is in Alarm | ||||||
| Trouble Light | If on system has an internal trouble | ||||||