Linear 21st Sentry CP90 Codes

System has up to 32 User Codes called PAC’s (Personal Access Code)
Master Code Usually User 02 (Any User Code can be set as Master)
Temp Code User 01
Secondary Code User 03 to 31
Duress Code User 03 to 31 (Any User Code can be set as Duress)
Installer Code User 32 (Default is 98765)

Temp Code 1 (Temporary Code)
1. Press # + Master Code + #
2. Enter Number of uses for this code (1 to 9) + #
3. Enter new Temporary Code + #

Erase Code 1 Press # + Master Code + # # # #

Add Code
1. Press #
2. Enter Master Code
3. Hold # until keypad beeps
4. Enter User Number (02 to 32)
5. Press # (User Number should show in display)
6. Enter new User Code (2 to 5 digits)
7. Press #
8. Enter 6 digit user level (Enter 8 0 2 0 0 1 if Master Code)
(Enter 8 0 0 0 0 0 if Standard User Code)
(Enter 0 0 1 0 0 1 if Duress Code)
9. Press # to finish
User levels in step 8
1st digit – Highest level of arming allowed (0 to 8) (see below)
2nd digit – Lowest level of arming allowed (0 to 8) (see below)
3rd digit – 0 = Normal code, 1 = Duress, 2 = Master, 3 = Arm Only
4th digit – 0 = Allow bypassing, 1 = do not allow bypassing
5th digit – 0 = No access output, 1 = Access output, 2 = Access only
6th digit – 0 = User can change own code, 1 = Master only changes code
1st and 2nd digits control arming levels
0 = Disarm
1 = Guard/Cancel (Local alarm only, no communication)
2 = Chime (Enables door/window chimes when open)
3 = Home arming
4 = Away arming
5 = Night arming
6 = Secure Night arming (Instant exterior zones)
7 = Phone Test
8 = Sensor Test
9 = Installer Mode