GE / ITI / UC Simon Trouble
Panel will begin beeping with any trouble, press SYSTEM STATUS to find trouble | |
AC Power Failure | Either AC transformer bad or plug-in not working |
System Battery Failure | Panel battery low, if replacing on Simon 1 see “Battery Test” |
Sensor Failure | Zone has failed to communicate with Keypad for 12 hours |
Sensor Low Battery | Sensor Battery Low |
Fail To Communicate | System can’t send signal to Monitronics |
Set Clock |
1. Open Keypad Cover and enter Master Code using RED Number Keys 2. Press CLOCK SET button 3. Set time with HOURS and MINUTES buttons 4. Press DONE when complete 5. Close Keypad Cover |
Sensor Test |
1. Open Keypad Cover and enter Master Code using RED Number Keys 2. Press TEST button once then press DONE (Leave cover open) 3. Keypad will say a list of all sensors that need tested 4. Open Door or Window, move by motion and it will be removed from list 5. When all sensors are tested keypad says “Sensor test complete press DONE” 6. Press DONE and close cover |
Battery Reset |
1. Open Keypad Cover and enter Master Code using RED Number Keys 2. Press TEST button once then press DONE 3. Close cover and press SYSTEM STATUS to see if low battery is gone |
Phone Test |
1. Open Keypad Cover and enter Master Code using RED Number Keys 2. Press TEST button twice 3. Keypad says “Phone test is On” If Phone test is good keypad says “Phone test ok” In 2 minutes If Test is bad keypad says “Phone Communication Failure” in 10 minutes |