GE / ITI / AC Simon XTI Basics
| Zones | Up to 40 wireless |
| Batteries | Keypad: 6.0VDC 1.2AH Lead-Acid |
| Door: CR123 | |
| Motion: AA | |
| Carbon: AAA | |
| Tilt: CR2023 | |
| Smoke: CR2025 | |
| Flood: CR2025 | |
| Freeze: CR2025 | |
| Image: Lithium AA | |
| Wallfob: CR2023 x2 | |
| Transformer: 9v AC | |
| Glassbreak: CR123 x2 | |
| Partitions | 1 |
| Downloadable | Yes |
| Panic Buttons | Press the ‘Emergency’ button at the top left of the screen |
| Status |
Press the ‘Gear’ icon in the bottom right hand screen Press the ‘Listen’ icon and it will tell you the status |
| Arm AWAY |
Press the ‘Press to Arm’ icon Press the ‘ARM ALL (AWAY)’ button |
| Arm STAY |
Press the ‘Press to Arm’ icon Press the ‘Doors & Windows Only (STAY)’ button |
| Disarm |
Press the ‘Press to Disarm’ icon Enter the master code or user code |
| Exit Menu | Press the ‘Close’ icon at the top right of the screen |
| Comm Test |
Press the ‘Gear’ icon in the bottom right hand corner of the screen Press the down arrow 3 times Press the ‘System Tests’ button Enter the MASTER code Press the ‘Enter’ button Press the ‘Comm Test’ button At this point, if it is cell primary, it will send a test signal, if it is landline it will test the landline |
| Silence Alarm |
Arm or disarm the system Press the ‘Gear’ icon, then the ‘Listen’ button |
| Door Chimes |
Press the ‘Gear’ icon Press the ‘On’ or ‘Off’ icons next to where it says ‘Chime’ |
| Bypass |
Press the ‘Gear’ icon Press the ‘Select’ button next to where it says ‘Direct Bypass’ Enter the access code Press the ‘Unbypassed’ icon next to the sensor name |
| Un-bypass | Disarm the system |
| Reset Smoke |
Press the ‘Gear’ icon in the bottom right hand screen Press the ‘Listen’ icon and it will tell you the status |
| Test Sensors |
Press the ‘Gear’ icon in the bottom right hand corner of the screen Press the down arrow 3 times Press the ‘System Tests’ button Enter the MASTER code Press the ‘Enter’ button Press the ‘Sensor Test’ button The panel will then display all of the sensors programmed to the panel Open/close each sensor and they should clear from the list, any sensor still on the list means they have not been tested |
| Set Time |
Press the ‘Gear’ icon in the bottom right hand corner of the screen Press the down arrow 3 times Press the ‘Enter’ button |
| Set Date |
Press the ‘Gear’ icon in the bottom right hand corner of the screen Press the down arrow 3 times Press the ‘Enter’ button |
| Clear Weather alerts |
1. Press the ‘Gear’ icon in the bottom right hand corner of the screen 2. Press Panel Status, and then press Listen and Clear. |