GE / ITI / UC Quick Bridge 8 Program
|
2 Wireless sensors per QuickBridge zone, up to 45 unsupervised Panics on zone 1 Use zones 2 to 8 for supervised Panic buttons (2 per QuickBridge zone) |
|
| Read Display |
(while in run mode) 3 top lights – Low Battery, Power, Supervisory, 8 bottom zone lights Light 3 ON + Low Battery & Power LED’s ON = Low Battery Zn 3 Light 4 ON + Supervisory & Power LED ON = Supervisory Trouble Zn 4 Light 1 ON + Power LED ON = Alarm Zn 1 |
| Wiring |
1. Wire + and GND to Aux + & Aux – on panel 2. Wire zones 1 to 8 to required zones on panel 3. Wire B S and T terminals to 3 zones for Battery, Supervisory and Trouble |
| Learn Sensor |
1. Open QuickBridge Cover (2 sensors max can be learned to each zone) 2. Press Program DIP Switch UP 3. Connect wire from GND terminal (3rd from right) 4. Touch GND wire to zone 1, zone 1 LED will blink for 5 seconds 5. Open Tamper on sensor (if no tamper available set sensor into alarm) 6. Zone light will blink once if sensor is learned 7. Slide Program DIP Switch DOWN to end |
| Delete Sensor |
1. Open QuickBridge Cover 2. Press Program DIP Switch UP 3. Connect wire from GND terminal (3rd from right) 4. Touch GND wire to zone to delete 5. Touch GND wire to zone to delete again, zone is now deleted 7. Slide Program DIP Switch DOWN to end |
| N/C or N/O Stuff |
(Default is N/C contacts) 1. Open QuickBridge Cover 2. Press Program DIP Switch UP 3. Press Tamper Switch once (Low battery LED will turn on or flash) 4. Touch GND wire to zone that will be N/O (Or all zones) 5. Zone light will turn off if N/O or turn on if N/C 6. Learn sensors with above steps |
| RF Supervision |
(Default is ON) 1. Open QuickBridge Cover 2. Press Program DIP Switch UP 3. Press Tamper Switch until supervisory LED lights 4. Touch GND wire to zone to enable or disable supervision |
| Keyfobs |
Zone 1 = Emulates Lock/Unlock buttons together Zone 2 = Emulates Lock or Unlock Button Zone 3 = Emulates Lights Button Zone 4 = Emulates Star Button Zone 5 = Emulates Lock Button (switches zone 5 output) Zone 6 = Emulates Unlock Button (switches zone 6 output Slide Program DIP Switch DOWN to end |