Change
Master Code
|
1. 9 + Master Code
2. 0320 + New Master code + #
3. * + 00 + #
|
Change Partition
Master Codes
|
1. 9 + Master Code
2. For each partition there is a different way to do it:
Partition 1: 0310 + New Code + #
Partition 2: 0311 + New Code + #
Partition 3: 0312 + New Code + #
Partition 4: 0313 + New Code + #
Partition 5: 0314 + New Code + #
Partition 6: 0315 + New Code + #
3. * + 00 + #
|
Add/Change
User Code
|
1. 9 + Master Code (Or Partition Master code)
2. 030 + User Number + 0 + New code + #
3. * + 00 + #
|
| Delete Codes |
1. 9 + Master Code
2. 030 + User Number + 0 + Master Code + #
3. * + 00 + #
|
Assign Partition
to a User
|
1. 9 + System Master + 3 + #
2. Keypad will display User Codes, press #
3. Use A or B to scroll left and right
4. Scroll to Regular Codes, press #
5. The display shows USER ### (1st available user number)
6. Use A or B to scroll and select desired user number, press #
7. The display shows USER ### – #### (e.g. 001 – 1234)
8. Press A or B until the display shows PARTITION ASSIGN.
9. Enter the partitions (1-6). The display flashes the partitions. Press # to finish
10. * + 00 + # to exit programming menus
Note: Please remember to create the user code before doing this!
|
|
Installer Code (Hard Reset)
|
1. Unplug alarm from outlet
2. Locate eprom
3. remove eprom
4. Wait 2 minutes
5. Keypad should do nothing while trying options
6. Plug prom back in
7. Plug power back in
8. 8 + 4321 + 0 + 0 should now allow access to programming
|
