1. Home
  2. GE ITI
  3. GE Commander
  4. GE Commander
 

GE / ITI / UC Commander III Basics

This system does NOT talk, it is also very rare
Downloadable No
Zones 4 Hardwired Zones + 1 Fire Zone (Zone 5)
Battery 9 volt Alkaline behind keypad (Customer can replace)
AC Transformer 9-volts
Downloadable Yes, customer MUST be home and answer the phone
Panic Buttons Police, Fire and Medical
Away Arm 4-digit Code + 3 (AWAY) (AWAY Light turns ON)
Stay Arm 4-digit Code + 2 (STAY) (STAY Light turns ON)
Instant Arm Arm system in STAY or AWAY + 4 (AWAY or STAY & NO DELAY Lights turn ON)
Disarm 4-digit Code + 1 (OFF) (AWAY or STAY Light turns OFF)
Silence Alarm 4-digit Code + 1 (OFF) (Press STATUS to clear display)
Quick Arm (If enabled)
Press COMMAND 3 to arm AWAY
Press COMMAND 2 to arm STAY
Press COMMAND 3 then COMMAND 4 to arm AWAY INSTANT
Press COMMAND 2 then COMMAND 4 to arm STAY INSTANT
Check Status
Press STATUS (Keypad lights will now show Zone status)
POWER Light = Zone 1
READY Light = Zone 2
STAY Light = Zone 3
AWAY Light = Zone 4
Bypass 1. Open Zone or Zones to bypass
2. Enter User Code + COMMAND + 3 to arm AWAY with bypass
or User Code + COMMAND + 2 to arm STAY with bypass
(All bypassed Zones return to normal when system is disarmed)
Reset Smoke 4-digit Code + 1 (OFF)
Door Chimes 4-digit Code + 7 (CHIME)
Alarm Memory Press COMMAND and STATUS

POWER Light = Zone 1
READY Light = Zone 2
STAY Light = Zone 3
AWAY Light = Zone 4
NO DELAY Light = Keypad Panic or CPU Tamper
FIRE Light = Zone 5 (Smoke Detector)
Light Control User Code + 0 will turn ON/OFF (if enabled, turns on for 15 minutes))
Phone Test 1. Enter Master Code + 8
2. If Phone test is good keypad will sound 4 beeps and keypad lights will flash
Sensor Test 1. Enter Master Code + 9
2. Open Doors/Windows/walk past motion
3. Keypad will sound rapid beeps on any sensor activation
4. Press Master Code + 1 (OFF) to end Sensor Test
Phone Access
(Optional) 		From any House Phone enter below commands
(On some systems * is replaced by #)

* + User Code + 3 Arm Away (Keypad/Phone will beep 3 times)
* + User Code + 2 Arm Stay (Keypad/Phone will beep 2 times)
* + User Code + 1 Disarm (Keypad/Phone will beep 1 time)
* + 411 System Status (Keypad/Phone will beep 1, 2 or 3 times)
* + 412 Turn X-10 Lights ON for 15 minutes
* + 412 again Turn X-10 Lights OFF (If ON)
* + User Code + 7 Door Chimes ON/OFF
* * * * * * Police Panic
(Remote accessing from outside phones is not possible)