GE / ITI / UC Caretaker Basics

System can be accessed by telephone or wireless keypad
Zones 30, usually wireless
Wireless Yes
AC Transformer 14 volts screwed into outlet in house
Battery
Main Panel – 12 volt 1.9 amp rechargeable Lead-Acid        
Door/Window – 3.6-volt Lithium
Motions – 3.6-volt Lithium
(Do NOT replace above batteries or programming of sensor erases!)
Smoke Detector – 2 9-volt Alkaline
(Smoke Detector batteries can be replaced if you do one at a time)
Downloadable No
Below Commands can be done on keypad or regular Telephone, some systems may use #
instead of * with phone commands (ie: use # + Code + 1 to Arm instead of * + Code + 1) )
Police Panic Press ****** on telephone or Police buttons on keypad
Quick Status Press * and # on telephone
Detailed Status Press * + 4-digit Code + # + 1 (Speaks arm status and AC/Battery status)
Arm Away Press * + 4-digit Code + 3 (Speaks “Alarm System is ON, Level 3”)
Arm Stay Press * + 4 digit code + 2 (Speaks “Alarm System is ON, Level 2”)
Instant Arm Arm system then press 6 (Speaks “Alarm System is ON, No Delay”)
Disarming Press * + 4-digit Code + 1 (Speaks “Alarm System is OFF, Level 1”)
Reset Smoke Press * + 4-digit code + 1
Bypass Arm system then press * + 4-digit code + Zone (01-30)
Force Bypass 1. Open Door or Window to bypass
2. Arm system in STAY or AWAY, Phone or keypad will beep rapidly
3. Press 4, system will say “Alarm System is ON, Sensor Bypassed”
Alarm History Press * + Master Code + # + 5 (Gives last 4 alarms, press # to clear memory)
Door Chimes Press * + Master Code + # + 2 (Speaks “Chime is ON” or “Chime is OFF”)
Activate Lights Press * + Master Code + # + 7 (If available)
(If arming enter 77 after Arming Command)
Phone Test Press * + Master Code + 8, system will say test OK or FAIL in 10 minutes)
Sensor Test 1. Press * + Master Code + 9 and leave phone off hook
2. Open Door/Windows, walk past Motion, press TEST on Smoke Det.
3. When all sensors are tested panel will say “All Sensors Test ok” and exit
(Wireless motions require no movement for 4 minutes prior to testing)
Remote Access 1. Call home phone and let ring twice then hang up
2. wait 10 seconds and call again (Or let ring 12 times)
3. System should answer and ask for 4-digit Code
4. Enter 4-digit Code, system will now act like it does at home