FBI Omni 2000 / 1219 Codes
Up to 8 User Codes, The User Number is part of the code to make 5 total digits Example: Code 1 starts with 1 + 4-digits, Code 2 starts with 2 + 4 digits etc |
|
If all power is lost to system User Codes will delete, customer should have “Fallback” code that re-programs Code 1 back into system, if this is unknown service must be set |
|
“Fallback Code” | (Hardcoded into system and cannot be changed by user) |
Master Code | Code 1 |
Secondary Codes | User 2 to 7 |
Duress Code |
User Code 0, enter 0 + 4-digit ambush code (if programmed) (Duress can also be used by pressing 1 to 7 then 4-digit Duress Code) |
|
|
Change Code 1 |
1. Press * 2. Press 1 + old 4-digit Master Code 3. Press 1 again (Zone 1 light will flash slowly) 4. Enter new 4 digit Master Code (Zone 1 light will stop flashing) (Remember when using code press 1 + 4 digit code to operate system) |
Program Code 1 |
(if power has failed) 1. Press * 2. Press 1 + “Fallback Code” 3. Press 1 again (Zone 1 light will flash slowly) 4. Enter new 4 digit Master Code (Zone 1 light will stop flashing) |
Add Code 2 to 7 |
(example below changes User Code 2) 1. Press * 2. Enter User Code 1 (Master Code) 3. Press 2 (Zone 1 light will flash slowly) 4. Enter new 4 digit Code (Zone 1 light will stop flashing) |
Delete Code 2 to 7 |
(example below deletes User Code 2) 1. Press * 2. Enter User Code 1 (Master Code) 3. Press 2 (Zone 1 light will flash slowly) 4. Press # (Zone 1 light will stop flashing) |