DSC PC 5020 / Power864 Basics
Zones | 64 total zones Wireless or Hardwired, 8 on-board Hardwired Zones | ||||||||||||
Wireless | Yes | ||||||||||||
Batteries |
|
||||||||||||
Partitions | Up to 8 | ||||||||||||
Downloadable | Yes, press * + 6 + Master Code + 5 + # to enable | ||||||||||||
Panic Buttons | Police, Fire and Medical | ||||||||||||
Arm Away | 4-digit Code or press AWAY 3 seconds (ARM light will turn ON) | ||||||||||||
Arm Stay | 4-digit Code or press STAY 3 seconds (ARM and BYPASS turs ON) | ||||||||||||
Quick-Arm | * 0 to Arm system (If Enabled) | ||||||||||||
Instant Arm | * 9 before arming in STAY or AWAY (Arm light will flash) | ||||||||||||
Disarm | 4-digit Code (Press # if any mistake is made) | ||||||||||||
Silence Alarm | 4-digit Code (Press # to stop keypad flashing) | ||||||||||||
Bypass |
1. Press * 1 (BYPASS or SYSTEM will flash) 2. Press Zone to bypass (01 to 64) (Zone light should turn ON) 3. Press # to exit (If this does not work try * 1 + Master Code + (01 to 64) + # ) |
||||||||||||
Reset Smoke | Press * 7 2 (If smoke continues to sound power down, smoke is bad) | ||||||||||||
Door Chime | Hold CHIME key for 3 seconds or * 4 to enable/disable | ||||||||||||
RESET Key | Resets Smoke Detectors | ||||||||||||
EXIT Key | Press to leave house without disarming, doors will arm again after 2 minutes | ||||||||||||
Alarm Memory | * 3 to view last alarm or for Alpha keypads see below | ||||||||||||
Event Buffer |
1. Press * 6 + Master Code 2. Press < or > keys to scroll to “Event Buffer” then press * 3. Use < key to move forward in time, use > key to move backward in time 4. Press * to toggle between Time/Date of Event and what the Event was Examples: Closing by User 40 = Master Code Armed System Opening by User 01 = User 01 Disarmed system Zone Fault Zone 24 = Zone 24 is in trouble |
||||||||||||
Sensor Test |
None, Arm system then trip sensors (Wireless motions require no movement for 4 minutes prior to testing) |
||||||||||||
Siren Test | * 6 + Master Code + 4 | ||||||||||||
System Clock | * 6 + Master Code + 1 and enter time (example: 1PM 11/26/99 is 1300112699) | ||||||||||||
Keypad Tone | Hold * until desired volume is found | ||||||||||||
Access Partition |
(If keypad is set for Global) 1. Press # for 2 seconds 2. Press 1 for 2 seconds for Partition 1, 2 for Partition 2 |
||||||||||||
Auto Arm | * + 6 + Master Code + 2 (3 beeps=Enable, 1 long beep=Disable) | ||||||||||||
Auto Arm Time | * + 6 + Master Code + 3 + HHMM (Military Time) |