1. Home
  2. Caddx
  3. Caddx NX6
  4. Caddx NX6
 

Caddx NX-6 Codes

Master Code User 01 (If Master Code is not known see bottom of page)
Secondary Code User 02 to 40
Hostage Code Set by Installer or downloading
Add Code 1. Press * 5 + Master Code (Ready light will flash)
2. Enter User (01 to 40) (Zone lights will/may turn on)
3. Enter new User Code
4. Press # to exit (Move to Authority Level below)
Authority Level 1. Press * 6 + Master Code (Ready light will flash)
2. Enter User (01 to 40)
3. Enter new Authority Level
(Zone lights show Authority Level, toggle lights ON or OFF by pressing 1 to 7)
  1 = Reserved, do not use
  2 = Arm Only Code (Babysitter Code)
  3 = Arm Only after Closing
  4 = Master Arm/Disarm (Master Code)
  5 = Arm/Disarm (Standard Secondary Code)
  6 = Bypass Zones (Allows bypassing of zones)
  7 = Open/Close Reporting (Leave OFF for Residential Accounts)
  8 = If ON do not change
4. Press # # to exit or if partitioned system press * once and see below
Delete Code 1. Press * 5 + Master Code (Ready light will flash)
2. Enter User (01 to 40) (Zone lights will/may turn on)
3. Enter * * * *
4. Press # to exit
Master Code
Not Known?

1. Press * + 8 (STAY/CHIME/EXIT/BYPASS/CANCEL lights will flash)
2. 9713 (Install code) (STAY/CHIME/EXIT/BYPASS/CANCEL lights flash, SERVICE turns ON)
(If incorrect Install code entered STAY/CHIME/EXIT/BYPASS/CANCEL will continue flashing)
3. Press 0 + # (STAY CHIME EXIT BYPASS CANCEL, SERVICE, ARMED turns ON)
4. Press 43 + #
5. Press 4 then * + # (Turns light 4 ON and makes Installer Code a Master Code)
6. Press EXIT twice (Exits Programming)
7. Now program new Master Code using 9713 as temporary Master Code