Caddx NX-4 Codes

Master Code User 01 (If Master Code is not known see bottom of page)
Secondary Code User 02 to 08
Hostage Code Set by Installer or downloading

Add Code
1. Press * 5 + Master Code
2. Enter User (01 to 08)
3. Enter new User Code
4. Press # to exit
(Ready light will flash)
(Zone lights will/may turn on)

(Move to Authority Level below)

Authority
Level
1. Press * 6 + Master Code (Ready light will flash)
2. Enter User (01 to 40)
3. Enter new Authority Level

(Zone lights show Authority Level, toggle ON or OFF by pressing 1 to 7) Alternate Attributes (Light 8 ON)
1 = Reserved, do not use 1 = Activate output 1
2 = Arm Only Code (Babysitter Code) 2 = Activate output 2
3 = Arm Only after Close Window     (Restrict arming time) 3 = Activate output 3 (V2 only)
4 = Master Arm/Disarm (Master Code) 4 = Activate output 4 (V2 only)
5 = Arm/Disarm (Standard Secondary Code) 5 = Arm/Disarm
6 = Bypass Zones (Allows bypassing of zones) 6 = Bypass Zones
7 = Open/Close Reporting (Leave OFF for Residential Accounts) 7 = Open/Close Reporting
8 = Alternate attributes (Off most the time) 8 = Alternate attributes

4. Press # # to exit

Delete Code
1. Press * 5 + Master Code
2. Enter User (01 to 08)
3. Enter * * * *
4. Press # to exit
(Ready light will flash)
(Zone lights will/may turn on)
Master Code
Not Known?
1. Press * + 8
2. 9713 (Install code)

3. Press 0 + #
4. Press 43 + #
5. Press 4 then * + #
6. Press EXIT twice
7. Program new Master
    use 9713 as temp Master
8. Go to programming
    with above steps/ turn off 4

(STAY/CHIME/EXIT/BYPASS/CANCEL lights will flash)
(STAY/CHIME/EXIT/BYPASS/CANCEL lights flash, SERVICE turns ON)
(If incorrect Install code entered STAY/CHIME/EXIT/BYPASS/CANCEL will continue flashing)
(STAY CHIME EXIT BYPASS CANCEL, SERVICE, ARMED turns ON)

(Turns light 4 ON and makes Installer Code a Master Code)
(Exits Programming)