Apex Advantage Basics
| System voice speaks all commands from keypad, there are no “Zone” lights | |||
| Zones | 80 | ||
| Resistors | 4.7k | ||
| Wireless | Yes, all use 9 volt Alkaline | ||
| Fuses | 2A for Siren, Fire, Aux, Smoke Detectors, 1 Amp for Logic Fuse (Main board?) | ||
| Battery | 12 volt rechargeable Gel-Cell inside main panel | ||
| AC Transformer | – 16.5 Volts 40 Va | ||
| Downloadable | No | ||
| Panic Buttons |
|
||
| System Status | Press STATUS, keypad will speak current status or open zones | ||
| Arm Away | Press A or Code + A (or * on Phone ) (Keypad says “Armed to Away”) | ||
| Arm Stay | Press H or Code + H (or # on Phone) (Keypad says “Armed to Home”) | ||
| Force Arm | (with zone open) Press A (Keypad says “Force Armed to Home”) | ||
| Instant Arm | Press H twice (Keypad says “Armed to Night”) | ||
| Disarm | 4-digit code (Keypad will say “Control is Disarmed”) | ||
| Reset | 4-digit code | ||
| Reset Smoke | – 4-digit code + 6 (Keypad will say “Smoke Power”) | ||
| Bypass |
1. Enter 4-digit code 2. Press 9 (Keypad says “BYPASS MODE, ENTER ZONE”) 3. Enter Zone (01 to ??) (Keypad says current bypass state of Zone) 4. Press A to enable bypass 5. Press H to end (To clear bypasses enter 00 in BYPASS mode) |
||
| Speak Time | 4-digit code + 1 | ||
| Monitor | Press MONITOR, keypad will speak whenever zone is open (talking chime) | ||
| F1 & F2 | Has specific functions (should be in Customer User Book) | ||
| Phone Test | 4-digit code + 0 | ||
| Set Clock |
1. Enter programming with 9173 2. Press 991, system will say “ENTER 11” 3. Enter 4-digit Military Time (0001 to 2399) 4. Enter 1-digit Day of Week (Sunday = 1) 5. Enter 2-digit Month (01 to 12) 6. Enter 2-digit Day (01 to 31) 7. Enter 2-digit Year |
||
|
Phone Access At Home |
All below commands can be done from the phone, the * key is A, # key is H 1. Pick up phone and enter Local Phone Access Code (different from User Code, customer should know this code) 2. Telephone will now act like keypad and use same commands 3. To finish either hang up phone or do nothing for 15 seconds |
||
| While Away |
1. Call home and let ring X times (X = programmed by installer) (If Answering Machine enter Over-ride digit #12) 2. When system picks up enter disarm code within 5 seconds 3. Telephone will now act like keypad and use same commands 4. To finish either hang up phone or do nothing for 15 seconds |
||
| 2-Way Voice |
(By Customer) 1. Access system with above steps 2. Press 9999 to activate “Listen Mode” 3. Press # to talk, * to listen 4. End by hanging up or press 0 to exit |
||