Vista-32FB 75 total codes, (02 to 75), any code can be a Master or Manager Code which can change other codes (Must be in the same partition)
You cannot pause more than 2 seconds while entering below commands or it won’t work
Add Code 1. Enter Master Code + 8
2. Enter User Code location (2 digit location) + new code
3. Keypad will ask “Add New User? 0 = NO, 1 = YES”, press 1
4. Keypad will ask “Authority Level ?”

     1 = Master Code (functions in assigned partitions and can add/delete codes)
     2 = Manager Code (all system functions in its partition and can add/delete codes except for Master)
     3 = Operator A (Normal system functions in its partition, cannot add/delete codes)
     4 = Operator B (Normal system functions in its partition, cannot add/delete codes or bypass zones)
     5 = Operator C (Can arm the system but only disarm if system was armed with this code)
     6 = Duress/Hostage Code

5. Keypad will ask “RFButton?” Normally enter 0
6. Keypad will ask “Multi Access?”

     0 to access one partition
     1 to access other partitions

7. If step 6 is Yes keypad will ask “Global Arm?” if Yes code will arm all partitions

Erase Code 1. Enter Master or Manager Code + 8 (CODE)
2. Enter User Code (2 digit location)
3. Enter Master or Manager Code again
3. Keypad will say “Okay to Delete? 0 = NO, 1 = YES”, press 1
4. Keypad will say “User Code Deleted”

Reprogram
Master Code
Installer Code + 8 + (2 digit location) + New Master Code (Keypad should beep)

View User Info 4 digit code + **, keypad will display Authority/Partition levels