Ademco Vista 21IP Codes

Master Code User 02
Partition 1 Master User 03
Part 2 Master User 33
Secondary Codes User 03 to 49 (User codes defaulted to partition 2 only are users 33-49)
Duress Code User 49 (Duress can be any location, but preferred in location 49) (NOTE: When adding duress to 49, ensure the code has access to all partitions)

eSmartSecurity Add the code to the contact and use the panel sync function.

Add Master Installer Code + 8 + 02 + New Master Code (Keypad should beep)
Change Master Master Code + 8 + 02 + New Master Code twice (Keypad should beep)
Add Code Master Code + 8 + User (03 to 49) + New Code (Keypad should beep)
Erase Code Master Code + 8 + User (03 to 49) + # + 0 (Keypad should beep)
After above commands keypad should beep indicating successful, if not try again
You cannot pause more than 2 seconds while entering below commands or it won’t work
Assinging Attributes Master code + 8 + User (03 to 49) + # + [Attribute Number] + [Value]
Attributes Values
1 = Authority Level 0-4 (see Authority Level table below)
2 = Access Group 0-8 (0= not assigned to a group)
3 = Active Partition(s) 1, 2, 3 (common) Enter partitions consecutively if more than one and press [#] to end the entries
4 = RF Zone # 1st zone number of keyfob
5 = Open/Close paging 1 for yes, 0 for no
Authority Levels

Level Value
User 0
Arm Only 1
Guest 2
Duress 3
Partition Master 4
(Can only be changed for users 03 – 49)

Function
Normal user. Cannot add/delete codes, set system clock, view event log, or program schedules
Code can only arm system
Code can only disarm system if was used to arm system
Performs security functions, but also silently sends a duress message to central station
Same as master, however only will work in assigned partition