| Zones | 8 Hardwired (1 to 8), 25 Wireless (10 to 35) | ||||||||
| Wireless | Yes | ||||||||
| Batteries |
|
||||||||
| Downloadable | Yes | ||||||||
| Partitions | 1 | ||||||||
| Panic Buttons |
|
||||||||
| Status | Press * if keypad shows NOT READY to view open zones | ||||||||
| Arm Away | 4-digit code + 2 (AWAY) to arm everything | ||||||||
| Arm Stay | 4-digit code + 3 (STAY) to arm all but motions | ||||||||
| Instant Arm | 4-digit code + 7 (INSTANT), this also bypasses motions | ||||||||
| Max Arming | 4-digit code + 4 (MAX) and everything arms instant | ||||||||
| Disarm | 4 digit code + 1 (OFF) | ||||||||
| Silence Alarm |
4-digit code + 1 (OFF) twice to turn off siren and reset display (If code is entered wrong, wait 2 or 3 seconds then try again) |
||||||||
| Bypass |
4-digit code + 6 (BYPASS) + zone (01, 02 03 etc) (keypad will beep, BYPASS + Zone should show, arm system) |
||||||||
| Alarm Memory | There is no alarm memory | ||||||||
| Reset Smoke |
4-digit code + 1 (OFF) twice to turn off siren and reset smoke (If this does NOT reset smoke detector set for service, smoke is bad) |
||||||||
| Door Chimes | 4-digit code + 9 (CHIME) | ||||||||
| Quick-Arm | # + 2 for AWAY, # + 3 for STAY | ||||||||
| Activate Relay | 4-digit Code + # + 7 | ||||||||
| Deactivate Relay | 4-digit Code + # + 8 | ||||||||
| Test Sensors |
4-Digit Code + 5 (TEST) Keypad will beep every 3 minutes Open sensors and keypad will sound End test with 4-digit Code + 1 (OFF) key (Wireless motions require no movement for 4 minutes prior to testing) |
||||||||
| Go/NoGo test |
(Verify signal strength) 1. Installer code # 4 2. Receiver gain is reduced by 50% 3. Keypad will beep 3 times to indicate signal reception 4. Enter 4-digit Code + 1 (OFF) |
||||||||
| Pager Signals |
|
