Ademco Vista 128 Codes

Vista-128 150 total codes, (002 to 150), any code can be a Master or Manager Code
You cannot pause more than 2 seconds while entering below commands or it won’t work
Add Code 1. Enter Master Code + 8 (CODE)
2. Enter User Code location (3 digit location) + new code
3. Keypad will ask “Add New User? 0 = NO, 1 = YES”, press 1
4. Keypad will ask “Authority Level ?”

1 = Master Code (Performs all functions in assigned partitions, can add/delete codes)
2 = Manager Code (Performs all functions in its partitions; Adds/deletes codes except Master)
3 = Operator A (Can perform all functions in assigned partitions, but cannot add/delete codes)
4 = Operator B (All functions in its partitions; cannot add/delete codes or bypass zones)
5 = Operator C (Arms system, only disarms if armed with this code) (Babysitter code)
6 = Duress/Hostage Code

5. Keypad will ask “RFButton?” Normally enter 0
6. Keypad will ask “Multi Access?”

0 to access one partition
1 to access other partitions

7. If step 6 is Yes keypad will ask “Global Arm?” if Yes code will arm all partitions

Erase Code 1. Enter Master or Manager Code + 8 (CODE)
2. Enter User Number (3 digit location)
3. Enter Master or Manager Code again
3. Keypad will say “Okay to Delete? 0 = NO, 1 = YES”, press 1
4. Keypad will say “User Code Deleted”
Reprogram
Master Code 		Installer Code + 8 + (3 digit location) + New Master Code (Keypad should beep)
View User Info 4 digit code + **, keypad will display Authority/Partition levels/User Number