Master Code User 02
Secondary Codes User 03 to 16
Duress Code User 16 (Duress can be any location, but preferred in location 16)

Add Master Installer Code + 8 + 02 + New Master Code (Keypad should beep)
Change Master Master Code + 8 + 02 + New Master Code twice (Keypad should beep)
Add Code Master Code + 8 + User (03 to 16) + New Code (Keypad should beep)
Erase Code Master Code + 8 + User (03 to 16) + # + 0 (Keypad should beep)
After above commands keypad should beep indicating successful, if not try again
You cannot pause more than 2 seconds while entering below commands or it won’t work
Assinging Attributes Master code + 8 + User (03 to 16) + # + [Attribute Number] + [Value]
Attributes Values
1 = Authority Level 0-4 (see Authority Level table below)
2 = Access Group 0-8 (0= not assigned to a group)
4 = RF Zone # 1st zone number of keyfob
5 = Open/Close paging 1 for yes, 0 for no

Authority Levels (Can only be changed for users 03 – 33)
Type 0 Normal user. Cannot add/delete codes, set system clock, view event log, or program schedules
Type 1 Arm only Code can only arm system
Type 2 Guest Code can only disarm system if was used to arm system
Type 3 Duress Code Performs security functions, but also silently sends a duress message to central station