Ademco Vista 100 Trouble

bF Long Range Radio trouble
NO AC AC Power Failure
BAT Backup Battery low
BAT 01 – 63 Zone has low battery (If 4 zones show at once likely Keyfob low battery)
BAT 00 Low Remote Keypad battery
Vista 100-128 Trouble Displays
CHECK 970 Bell 1 Output Trouble
CHECK 971 Bell 2 Output Trouble
CHECK 972 Earth Ground Fault
CHECK 973 J2 Trigger Output Trouble
CHECK 974 Dialer 1 Trouble
CHECK 975 Dialer 2 Trouble
CHECK 987 Voice Module Trouble
CHECK 988 2nd RF Receiver not receiving signals
CHECK 990 1st RF Receiver not receiving signals
D1 or
SYSTEM BUSY System in wait mode, if it stays on system has internal problem
CA Alarm was canceled, this is not a trouble
CC Panel is being downloaded by Tech Support
EA Exit Alarm, this is not a trouble, customer armed system left and didn’t close door before delay expired
FC Fail to Communicate
E4 or E8 More zones were programmed than wireless receiver is capable of
OC Open Circuit, bad keypad wire
One Beep
every 40 Sec
System is in Test Mode (Press Code + 1 to exit Test Mode)
Remove old batteries, hold Smoke test button 30 seconds, Insert new batteries