Ademco Vista 100 Codes

Vista-100 128 total codes, (002 to 128), any code can be a Master or Manager Code which can change other codes (Must be in the same partition) You cannot pause more than 2 seconds while entering below commands or it won’t work
Add Code	1. Enter Master Code + 8 (CODE) 2. Enter User Code location (3 digit location) + new code 3. Keypad will ask “Add New User? 0 = NO, 1 = YES”, press 1 4. Keypad will ask “Authority Level ?” 1 = Master Code (perform all system functions in assigned partitions and can add/delete codes) 2 = Manager Code (perform all system functions in assigned partitions and can add/delete codes except for Master Code) 3 = Operator A (perform system functions in assigned partitions, but cannot add/delete codes) 4 = Operator B (perform system functions in its partitions, but cannot add/delete codes or bypass zones) 5 = Operator C (arm the system but can only disarm if the system was armed with this code) (Babysitter code) 6 = Duress/Hostage Code 5. Keypad will ask “RFButton?” Normally enter 0 6. Keypad will ask “Multi Access?” 0 to access one partition 1 to access other partitions 7. If step 6 is Yes keypad will ask “Global Arm?” if Yes code will arm all partitions
Erase Code	1. Enter Master or Manager Code + 8 (CODE) 2. Enter User Number (3 digit location) 3. Enter Master or Manager Code again 3. Keypad will say “Okay to Delete? 0 = NO, 1 = YES”, press 1 4. Keypad will say “User Code Deleted”
Reprogram Master Code	Installer Code + 8 + (3 digit location) + New Master Code (Keypad should beep)
View User	Info 4 digit code + **, keypad will display Authority/Partition levels