1. Home
  2. Ademco
  3. Ademco Vista
  4. Ademco Vista

Ademco Vista 100 Basics

Zones 8 Hardwired, up to 87 Hardwired or Wireless
Wireless Yes
Battery
Main Panel
AC Transformer
Doors/ Windows/Motions
Smoke Detector
Keyfobs and Panics 		12 volt rechargeable Gel-Cell
16.5 volts screwed into outlet somewhere in house
3-volt Lithium (Panasonic CR123A)
2 9-volt Alkalines
2 3-volt Lithium (CR2025 Hearing Aid type) or CR2430 Lithium
Partitions 8
Downloadable Yes
Panic Buttons
Police Panic
Fire Panic
Medical Panic 		– * and #
– 1 and *
– 3 and #
Status Press * if keypad shows NOT READY to view open zones
Arm Away 4-digit code + 2 (AWAY) to arm everything
Arm Stay 4-digit code + 3 (STAY)
Instant Arm 4 digit code + 7 (INSTANT), also bypasses motions
Quick-Arm # + 2 for AWAY, # + 3 for STAY (If Enabled)
Max Arming 4-digit code + 4 (MAX), arms everything including motions instant
Disarm 4 digit code + 1 key (OFF)
Silence Alarm 4-digit code + 1 (OFF) twice to turn off siren and reset display
Bypass 4-digit code + 6 (BYPASS) + Zone (01, 02 03 etc) (Three digit zone on Vista-100 or higher ie, zone 001)
Quick Bypass (if enabled) 6 (BYPASS) + Zone to bypass (01, 02 03 etc) (Three digit zone on Vista-100 or higher ie, zone 001)
Door Chimes 4-digit code + 9 (CHIME)
Reset Smoke 4-digit code + 1 (OFF) twice
(If this does NOT reset smoke detector set for service, smoke is bad)
Alarm Memory 1. 4-digit code + # + 6 + 0, select 0 for Recent or 1 for Complete log
2. Select Partition (press 0 for all partitions)
3. Use 1 for previous log entries or 3 for next log entries
4. Press 8 to select a catagory and 8 again for next entry
5. Press * to exit
Test Sensors 4-digit Code + 5 (TEST)
Keypad will beep every 3 minutes
Open sensors and keypad will sound
End test with 4-digit Code + 1 (OFF) key
(Wireless motions require no movement for 4 minutes prior to testing)
Setting Clock (some systems may not allow changing Clock)
1. Enter Master Code + # + 63, display will show current Time/Date
2. Enter correct (00 to 12) Hour then press *
3. Enter correct Minutes (00 to 59) then press *
4. Press any key from 0 to 9 to toggle AM and PM then press *
5. Enter correct Month (01 to 12) then press *
6. Enter correct Date (01 to 31) then press *
7. Enter correct Year (99 or 00 etc) then press *
8. Press * after cursor is in the Year setting to exit
Access Partition User Code + * and Partition (0, 1, 2 etc)
View Message Hold 0 for 5 seconds to view Monitoring Station Messages
View User Info 4 digit code + ** to display Authority and Partition levels
Display Zones Hold * for 5 seconds to view all zone descriptions
Go/NoGo Test Installer code 5, Receiver gain is reduced by 50%
(Keypad will beep 3 times to indicate signal reception)