bF | Long Range Radio trouble |
BAT | Panel Battery low |
BAT 01-40 | Zone Low Battery (4 zones showing at once likely wireless keyfob) |
BAT 00 | Low Remote Keypad battery |
CHECK 01-40 | Zone is not communicating with panel, may be bad |
CHECK 9 | Wireless Receiver or Module failure (check sections 22, 24, 25, 28, 29) |
CHECK 70 | Supervised Bell Circuit trouble (Make sure *91 is 0 to prevent this) |
CHECK 87 | 4285 Voice Module Trouble |
CHECK 97 | Short in Polling Loop |
CHECK 88 | Wireless Zones not communicating with 2nd Receiver |
CHECK 89 | 2nd Receiver Failure |
CHECK 90 | Wireless Zones not communicating with 1st Receiver |
CHECK 91 | 1st Receiver Failure |
CHECK 94 | Phone Line Trouble |
OC | Open Circuit, bad keypad wire |
FC | Fail to Communicate |
CC | Panel is being downloaded by Tech Support |
D1 or SYSTEM BUSY |
System is in wait mode, if remains system has internal problem or is disabled |
CA | Alarm was canceled, this is not a trouble |
EA |
Exit Alarm, this is not a trouble, customer armed system left and didn’t close door before delay expired |
E4 or E8 | More zones were programmed than wireless receiver is capable of using |
NO AC | AC Power Failure |
One Beep every 40 Sec |
System is in Test Mode (Press Code + 1 to exit Test Mode) |
Smoke Batteries |
Remove old batteries, hold test button 30 seconds, add new batteries |