Ademco Safewatch 2000 Trouble |
|||
|---|---|---|---|
| Check 9 | Generic trouble display/expansion module failure | ||
| NO AC | AC Power Failure | ||
| BAT | Panel Battery Low | ||
| BAT | xxx Wireless zone low battery where xxx is the zone number | ||
| Check 01 to 34 | Zone is not communicating with panel | ||
| D1 | System is in wait mode, system may have an internal problem | ||
| System Busy | System is in wait mode, system may have an internal problem | ||
| CA | Alarm was canceled, this is not a trouble | ||
| Canceled Alarm | Alarm was canceled, this is not a trouble | ||
| CC | Panel is being downloaded by Tech Support | ||
| Modem Comm | Panel is being downloaded by Tech Support | ||
| 94 | Telephone Line Failure | ||
| 70 | Siren supervision failure | ||
| 90 | RF Jam detected | ||
| 00 | Bat Wireless keypad low battery | ||
| Cd | Phone test okay | ||
| dO | Dialer off | ||
| dd | Walk test is active (Code + 5 + 0) to exit | ||
| dC | Download complete | ||
| dF | Download failed | ||
| Alarm xxx | Zone is or was in alarm where xxx is the zone number | ||
| Fault xxx | Zone is faulted where xxx is the zone number | ||
| Check xxx | Zone is not communicating with the panel where xxx is the zone number | ||
| EA |
Exit Alarm, this is not a trouble, customer armed system then left and didn’t close door before delay expired |
||
| FC | Fail to Communicate | ||
| OC | Open Circuit, bad keypad wire | ||
| Beep every 40 sec |
System is in Test Mode (Press Code + 1 to exit) | ||
| Smoke Detector |
4-digit Code + 1 (OFF) 4-digit Code + 1 (OFF) to turn off siren and reset Smoke Detector (If this does not work power down system, Smoke Detector is bad) |
||
