| Part 1 Master Code |
User 1 (Master Code is not changable by User) |
| Part 2 Master Code |
User 2 (Master Code is not changable by User) |
| User Codes |
User 3 to 4 |
| Duress User |
One digit higher than User Code (User Codes should not end in 9) |
|
| User Codes are only changable by that Partition’s Master Code |
| Add Master |
Installer Code + 8 + Partition (1 or 2) + Master Code |
| Add Code |
Master Code + 8 + User (3 to 4) + New Code |
| Erase Code |
Master Code + 8 + User (3 to 4) wait 5 seconds |
| After above commands keypad should beep indicating it was successful, if not try again |
| You cannot pause more than 2 seconds while entering below commands or it won’t work |
